ROBOTICS / HARDWARE / RESEARCHChina sourcing · International enquiries

TECHNICAL BUYING GUIDE

Robot Hand SDK & Integration Checklist

What to request before buying a robot hand: interfaces, example data, timing, calibration and a repeatable acceptance test.

Prepared by TOBI Hands · Procurement checklist, updated 20 November 2026

Define the command and observation space

List the independently commandable joints and the feedback your experiment needs. Ask for joint names, limits, units, supported control modes and a kinematic model for the exact revision. Separate measured joint position from a commanded target; a command acknowledgement is not evidence that a movement completed.

Request a reproducible SDK example

Ask for the supported host operating system, processor architecture, language binding, firmware version and licence. Request a minimal connect, read-state, command and stop example. Record whether ROS 2 support is maintained by the manufacturer, provided by a third party or still an integration task.

Measure timing across the complete system

A transport bandwidth or headline update rate does not establish end-to-end latency. Define where timestamps are recorded, whether state messages are buffered, how missing commands are handled and what happens after connection loss. Test the intended controller and host together.

Check the mechanical and electrical scope

Confirm handedness, flange drawing, fasteners, cable exit and clearance. List the controller, power supply, connectors and cables included in the quotation. Ask for peak-current conditions, startup sequence and a supplier-documented stop procedure.

Write a small acceptance protocol

Choose repeatable objects and poses, a short motion sequence and a required state log. Record firmware, command settings, failures and recovery behaviour. Agree the pass criteria and responsibility for troubleshooting before committing to the configuration.

What to send with your enquiry

Include your task, preferred model if known, required outputs, host software, interfaces, quantity, destination and acceptance criteria. Use the project brief below to request a configuration review.

Download the requirements checklist · Compare selection criteria

Manufacturer reference

Wuji Hand manufacturer documentation. Refer to the exact model and firmware documentation. This link does not imply a dealership, partnership or confirmed availability.

TOBI / HANDS

Request selection & pricing

Fields marked * are required.

Add technical & purchasing details

Your request is saved securely in this website’s enquiry desk.

EmailDiscuss your project